How to wash a tool backpack
It is very important to know the right technique when you want to know how to wash a tool backpack. First of all, it is very important not to use too much soap when you are washing your backpack. Too much soap residue can clog up your backpack’s internal pump and the cleaning head inside it. In addition, too much soap can damage the fabric of the backpack with hard hat holder.
Make sure it is unzipped
So, let’s talk about the best way to clean a tool backpack. Before you do anything, make sure that the backpack is unzipped. Use a damp sponge to wet the interior surface of the backpack. When you are done wetting the backpack, wring it until the water runs out of the backpack.
Use a damp cloth or towel
If you did not notice, the water from the aforementioned exercise is going to run out of the backpack and onto the ground. To prevent this, pick up a damp cloth or towel and wipe out the backpack. Remember to do this for each piece of the backpack until you have cleaned the entire tool backpack.
Pump and wheels
After doing the above step, it is now time to clean the backpack’s pump and wheels. Put the backpack on a flat surface and fill it up with some water. Start scrubbing the soap off using the scrub brush part of the brush. Rinse the backpack off after every rinse.
Use medium heat
Next, get out your dryer and set it to medium heat. On medium heat, the backpack will become liquefied. When the backpack is liquefied, you should be able to wipe out the moisture on its surface. At this point, the backpack should look like it was just cleaned by a sponge.
Use a hairdryer
Next, you’ll want to dry the backpack in a clean and dry place to help prevent damage. Using a hairdryer will do the job nicely but be careful not to use it at high heat. Using a blow dryer on a low setting will be just fine. To finish off the process of how to wash a tool backpack, remember to apply a protective sealant. This will help keep your backpack fresh and save you from the hassle of constantly having to rub and scrub the stubborn stains away.
Rent a washing machine
If you have a large number of backpacks to wash, you may want to consider renting a washing machine or dryer from your local supermarket or hardware store. Wash the backpacks using cold water only. Use a mild detergent, preferably one without fragrances or dyes. If possible, dry each backpack on a hanger lined with a soft towel.
Put to airing closet for drying
When you’re done cleaning, put the backpack in an airing closet for drying. Wait until the material in the backpack has dried before putting it away. Let the backpack dry on its own for about an hour before putting it away. If you put it away too soon, you risk getting mould from the drying process on the material in the backpack. It is also a good idea to set up a fan in the air to speed up the drying process. Avoid using harsh detergent as this will damage the material used for the backpack.
Use a hairdryer
Now that your backpack is clean, you need to dry it thoroughly using a hairdryer. While the backpack is being dried, carefully lift the bottom and roll it up into a ball shape. Then using a dry cloth, gently brush the dirt off the backpack making sure to avoid getting the fibres into the fabric. When you are finished, you can now put your new, clean tool backpack back into your gear bag. The entire process only takes a few minutes. If you follow them regularly, your backpack should last for a very long time.
